Over 10 years ago, we built our first gauge pod for the Blue MINI. Recently we added oil pressure and temperature gauges. When we decided to move the oil pressure gauge from the center console to the speedo cluster, we also decided to swap out the DIY bracket for the CravenSpeed Flexpod.

Installation is very simple.  Unbolt the speedo cluster, unplug the cable, and bolt the bracket on to the back of it. We wanted to reuse our old Autometer gauges so that took a little modification.  First we had to make room in the gauge pod back cover for the lamp socket assembly (we’re using non-standard LED bulbs so they sit higher higher than stock ones.)

Next we had to cut down the threaded pins on the gauges.  Cut them to about the same length as the electrical connectors and they will sit flush with the spin on nuts. Be sure to cover the lamp socket opening so you don’t fill the gauge with metal shavings

It’s a tight fit to the dash, but a very clean look.  We were also able to lower the gauges relative to the steering wheel to better see the gauge faces in the smaller aftermarket Sparco wheel.