Hella Fog Lamps

October usually marks the end of track season here in the Mid-Atlantic. Since the first event of the new year is normally in April, we like to swap out some of the go-fast bits that will take a needless beating during the winter months. That generally means swapping out track pads, removing the cold air intake and splitter, and eventually putting on winter tires. Since we removed the stock fog lights to use the openings for brake ducts, this also meant we would drop the bumper cover, remove the wheel liners and put the lights back. But this year, we thought we’d try something different. Since we had a few of the Alta Rally Light Bars in the shop, we thought we’d see how difficult they are to install. (Feb 17 update: Unfortunately it appears Alta has stopped making these. We’re working on making our own instead. ┬áCheck back soon.)
Lightbar
The Alta Rally Light Bar mounts to the rear of the bumper and protrudes through the lower grille. It has four light mounting points, but we only used the two outer positions. If you’re adept at removing the bumper cover and bumper, this project could be completed in about an hour if you are using the exiting fog light wiring. Double that if you are wiring up a new switch, and double that again if you’ve never removed the bumper.
Drill Here
Follow the instructions included with the bar, though you can probably use a smaller drill than the 7/16 inch bit they recommend. Just be sure your bit is slightly larger than the bolts used. Also note that the bumper is curved. Once installed and tightened, you will need to use a large philips screwdriver to get leverage to bend the mounting points back toward each other in order to fit the cross member. Do this before you place the bumper back into the cover to decide where you need to cut the grille for them to pass through.
mounted lights
Since we know we’ll be removing the lights to install the splitter again in the Spring, we added quick-connects near where the wire comes through the grille, and attached the other end of the wire to the connectors for the stock fog lights. This way we use the stock fog light switch, and the fogs dim when the high-beams are activated. The Hella lamp kit includes mounting brackets, wire, a relay, and a switch. The lamp kit is available with either fog lamps (short, wide beam) or driving lamps (long, narrow beam). We chose the fog lamps and also optional yellow lens shields.
side view
For about $200 plus a couple hours of your time, this kit provides ample lighting and is quite a bit less expensive than the stock kit. You do have to remember, however, that the lamps sit a couple of inches in front of the front bumper.